19
ENGLISH
Perform the
“7.2.1 Weekly brew group cleaning cycle”
procedure.
>
You can now install the AquaClean water filter if used: refer to the
“10.2 AquaClean
water filter”
chapter.
At the end, the machine goes back to the main menu. It is recommended to perform
a
“5.2.3 Manual rinse cycle”.
7.5.1 Interruption of the descaling cycle
Once the descaling cycle has started, you must complete it till the very end without
turning off the machine.
>
In case you get stuck during the cycle or in case of power failure or accidental
disconnection of the power cord, you can exit by pressing the STAND-BY button.
>
If this occurs, empty and rinse carefully the water tank, then fill it up to the CALC
CLEAN level. Follow the instructions provided in the
“5.2.3 Manual rinse cycle”
chapter
before brewing any product. If the cycle was not completed, the machine will require
another descaling cycle to be performed at your earliest convenience.
8. Default settings
8.1 List of default settings
Display
Setting
Value
Description
COFFEE
TEMP
MAX
MED
MIN
Coffee
temperature
average
Coffee brewing temperature setting.
STANDBY
180’
60’
30’
15’
Stand-by time
15 minutes
Stand-by time setting.
DISPLAY
CONTRAST
Contrast
average
Display contrast setting.
WATER
HARDNESS
4
3
2
1
Water hardness
4 (very hard
water)
Water hardness setting. For further details, please
refer to the
“5.3.1 Water hardness measurement and
setting”
chapter.
WATER
FILTER
0/8
FIL
TER
0/8
FIL
TER
ON
AquaClean water
filter
to be installed AquaClean settings. For further details, please refer
to the
“10.2 AquaClean water filter”
chapter.
8.2 Changing the default settings
It is possible to customise the machine functions through the programming menu. The
machine must be turned on and ready to work.
If necessary, refer to the
“8.1 List of default settings”
chapter.
>
Press the MENU button and scroll through functions list to select the function whose
settings are to be modified:
Note: the images at the side refer to a sample function.
>
Press the OK button to select the desired function.
Once selected:
>
Press the UP button to increase the value.
>
Press the DOWN button to decrease the value.
>
Press the OK button to confirm the change.
When the change has been implemented, the OK message will be displayed.
The modified but unconfirmed values will not be stored.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3 minutes.
8.3 Reset to the default settings
It is possible to restore the default settings through the programming menu. The
machine must be turned on and ready to work.
>
Press the MENU button and scroll through functions list to select the RESET function.
>
Press the OK button to select the function.
START
CALC
CLEAN
FI
LT
ER
START
CALC
CLEAN
DISPLAY
CONTRAST
RESET
Incanto_OTC_EN-IT-DE_Rev01.indb 19
27/03/15 12:11