Saeco Incanto HD8917/48, Руководство пользователя

Страница: 31 / 80

5
Pour the descaling solution in the water tank. Fill the water tank
with fresh water up to the CALC CLEAN level indication. Place the
water tank back in the machine. Press the OK button to confirm.
- The first phase of the descaling cycle starts. The machine
starts dispensing the descaling solution at intervals.
- The display shows the descaling icon, the phase indication
and the duration. This first phase takes 20 minutes.
6 Let the machine dispense the descaling solution until the water
tank is empty.
7 Remove the water tank and rinse it.
8 Fill the water tank with fresh water up to the CALC CLEAN level
indication. Place the water tank back in the machine and press OK.
9
Remove and rinse the milk carafe. Fill the milk carafe with water
up to the MIN level indication. Insert the milk carafe into the
machine and open the milk froth dispensing spout.
10
Remove and empty the container and place it back under the
coffee dispensing spout. Press OK to confirm.
11 The second phase of descaling starts, which is a rinsing cycle.
This phase takes 3 minutes. The display shows the rinsing icon
and the duration of the phase.
Note: If the water tank is not filled up to the CALC CLEAN level,
the machine may require another rinsing cycle.
12
Wait until the machine stops dispensing water. The descaling
procedure is finished when the tick appears on the display.
13 Press the OK button to exit the descaling cycle. The machine
starts heating up and performs the automatic rinsing cycle.
14
Remove and empty the container.
15 Perform the 'Weekly cleaning of the milk carafe' procedure to
clean the milk carafe after descaling.
16
Clean the brew group by performing the 'Weekly brew group
cleaning' cycle.
17 Reinstall the AquaClean filter.
What to do if the descaling procedure is interrupted
Once the descaling procedure has started, you must complete it
till the very end without switching off the machine. If the machine
gets stuck during the cycle, you can exit the descaling procedure
by pressing the standby button. If this occurs, or in case of a power
failure or accidental disconnection of the cord, do the following:
1
Empty and rinse the water tank thoroughly.
2 Fill the water tank up to the CALC CLEAN level indication and
switch the machine back on. The machine will heat up and
perform an automatic rinsing cycle.
3
Before brewing any beverages, perform a manual rinsing cycle,
see section 'Manual rinsing cycle'.
Note: If the descaling procedure was not completed, the machine
will require another descaling procedure as soon as possible.
MAX
CAL
C
CLE
AN
CALC
CLEAN
1
2
English
31
4219_460_3631_2_Lux_Booklet_A5_v2.indd 31 21/07/17 14:30