42
Help Message Displayed
How to Reset the Message
TURN CARAFE
INTO
BREWING POSITION
ESC
A beverage with milk has been selected. The machine requires the carafe handle
spout to be placed into dispensing position.
Press the button "ESC" to cancel the selection.
TURN CARAFE
INTO
RINSING POSITION
ESC
The carafe rinse function has been selected.
Press the button "ESC" to cancel the selection.
INSERT CARAFE
ESC
The selected operation requires the milk container for brewing. Insert the container
in the machine as specified in the manual.
Press the button "ESC" to cancel the selection.
Perform a descaling cycle on the machine.
When this message is displayed, it is still possible to use the machine, but its correct
operation might be compromised.
Damages caused by failure to descale the machine are not covered by warranty.
The machine requests the "Intenza" water filter to be replaced with a new one.
Replace the filter as described on page 7.
The alarm is displayed only if the "Enable Filter" function is set to "ON".
(See page 28).
Flashing red light. Machine in Stand-by.
The Stand-by settings can be changed.
Press the "
" button.
RESTART TO SOLVE
An event has occurred which requires the machine restart.
Take note of the code (E xx) shown at the bottom.
Switch off the machine, wait 30 seconds and then switch it on again. If the problem
persists, contact the service centre.
maCHIne WarnInGS
Downloaded from CoffeeMachineManual.com Manuals
