Saeco AMBRA SUP 015VR, Руководство по эксплуатации и техническому обслуживанию, Страница: 28 / 36

English
28
When setting the desired quantity, the following message
appears on the display:
“HOT WATER “
“PROGR. QUANTITY “
Place the glass or cup under the hot water spout (ref. 7 -
Fig. 1) and press the hot water selection key. Water is dis-
pensed automatically.
8.5 Messages and special
warnings
The machine shuts off automatically - partially or totally -
when the bean hopper is empty or the machine is malfunc-
tioning. The cause of the shut-off appears on the display
located on the control panel.
If the display shows a warning message, contact the SUPPLY
OPERATOR.
Bean hopper electronic control
When the bean hopper is empty, the machines stops grind-
ing after about 20 seconds. Fill the bean hopper following
instructions outlined on page 24.
Coffee beans protection against impurities
Even the best coffee beans may contain impurities (stones,
metallic parts, etc.)
If a foreign body falls into the grinder, a special noise is
produced: turn the machine off immediately!
Grinding stops automatically in about 15 seconds thanks to
the electronic control.
Important
To avoid damaging the coffee grinder motor do not re-start
the machine until the foreign body has been removed.
Follow the procedure outlined on page 31.
Water level electronic control
The machine stops automatically when the water level in the
tank is below the minimum value detected by the floating
indicator (ref.
10
- Fig. 1).
Fill the tank following instructions outlined on page 24.
9 - MAINTENANCE
9.1 Foreword
Warning
Before performing maintenance and /or cleaning procedures,
unplug the machine and wait until it is cold.
Follow the instructions contained in this manual to obtain
maximum beverage quality and guarantee the correct
functioning of the machine.
The machine and its non-removable components must be
cleaned with cold or warm water using non abrasive sponges
and wet cloths unless otherwise stated (this operation must
not be performed on exposed electrical components).
•
Do not use detergents or solvents that could modify the
shape or functionality of the machine and its compo-
nents.
•
Do not soak the machine in water or other fluids: the
machine will be damaged.
•
Do not wash component parts in the dishwasher.
•
Always hand-dry the machine components, do not place
them in the oven or microwave oven.
•
Do not use direct jets of water.
•
All the components that require cleaning are easily
accessible and do not require the use of tools.
•
Regular maintenance and cleaning keep the machine in
good condition and guarantee its efficiency for a longer
time while respecting standard hygienic regulations.
•
The machine counters keep track of the number of bev-
erages dispensed and allow standard maintenance
interventions to be programmed by the maintenance
technician.
Important
When performing maintenance operations follow the timetable
outlined in section. 14 in the
general maintenance table
.
Warning
In case of failure and/or malfunctioning contact an APPROVED
ASSISTANCE CENTER.