SAE J2716 Gateway User’s Manual
MACH SYSTEMS s.r.o.
Page
8
of
17
4.4.2
SENT-CAN
The SENT-CAN device offers two possibilities to power the device - over CON1 (like SENT-RS232) or
over CON2 (DSUB9).
Figure 4 SENT-CAN Power
4.5
CAN Bus Termination
The SENT-CAN does not have an internal termination resistor on the CAN bus. Therefore, a proper
termination of the CAN bus is needed. The user needs to make sure the CAN bus is properly terminated
at both ends.
Figure 5 SENT-CAN Bus Termination
4.6
Factory Reset
The reset button is located on the side of the device. For resetting to factory defaults, power the
device, wait a few seconds and then press and hold the button for 10 seconds. The button can be
pressed by tweezers or a pen.
