SAC ROTO-PRESS 904, Руководство по эксплуатации и обслуживанию

Страница: 9 / 43

2
3. Position the ROTO-PRESS in a straight line with the tractor in the direction that you want to
bag, making sure that the wheels of the tractor are pointed straightforward. See Figure 1.
Keep checking the tractor front wheels while filling the bag, making sure that they are
straight at all times. Many people will grab the steering wheel when getting on/off. Try not
to do this. Remember to leave an additional 10 to 15 feet of room to put the bag on when
positioning the tractor and bagger.
Figure 1
4. In certain wet or soft conditions, the Roto-Press will try to push the tractor sideways. To
correct this, use a section of chain with binders, hook one end to the grab hooks located on
the ROTO-PRESS frame near the bottom of oil bath and attach the other end of the chain to
the tractor axle. Do this on both sides of the machine.
TRANSPORT LIGHTING
1. When you receive your ROTO-PRESS, the transport lighting should be in the open position,
meaning the lights are visible from the rear of the machine. Once the machine is positioned for
bagging, the lights must be moved into the closed position. The light assemblies are accessible
from the front of the machine, located behind the wheels. To close the light, pull the pin
holding the light assembly and pull the assembly forward until it bumps against the stop.
Replace the pin back into the additional hole in the light assembly bracket to hold the light
assembly in the closed position.
2.
Before transporting the machine to a new location, reverse the process as described above.
It is very important to reposition the lights each time the machine is transported.
BAG INSTALLATION
1. Loosen the single chain loop on the bungee cord from the notched bar on the bag apron and
then disconnect the hooks on both ends. Disconnect the yellow rope with hooks from the
bagger’s front shroud. Unhook the apron chain from the apron support and lower apron to the
ground.
Figure 2