Sabre ED-35, Руководство пользователя

Страница: 7 / 14

Setups
Installation
CAUTION : Before you begin, make sure your mixer-amplier is disconnected from the power
source, with the power switch in the “OFF” position and all level controls turned completely
down (counterclockwise). You may stack mixer-ampliers without using a cabinet or you may
place a single mixer-amplier on a surface with 12-inches (about 30cm) of air space around
the unit for convection cooling.
We recommends using pre-built or professionally wired balanced line. 22 to 24 gauge cables.
Figure 2.1 shows connector pin assignments for wiring. The RCA input connections can also
be used for unbalanced inputs.
Setups
Wiring guide
Choose input wire and connectors
[ Figure 2.1 Input wire and connectors ]
BALANCED UNBALANCED
Unbalances 1/4” Connector Balances TRS 1/4” Connector
XLR Balanced Wiring Guide
For connection of balanced and unbalanced plugs,
ring and sleeve have to be bridged at the stereo plug
SOURCE TO DESTINATION
straln rellef clamp
sleeve
tip
sleeve
ground/shleld
tip
signal
straln rellef clamp
sleeve
tip
rlng
sleeve
ground/shleld
tip
hot
rlng
cold