Service Interval Chart - Page 41
SERVICE INTERVAL CHART
Servicing Your Machine
Please use the following timetables to perform routine maintenance on your machine. Service
procedures included in this manual but not on this chart are to be performed on an as needed basis.
After the first 5 hours of operation (break-in period):
• Check/tighten all hardware
• Check wheel bolt torque (also check again at 50 hours for break-in, then every 200 hours)
• Change engine oil (also change oil again at 50 hours for break-in, then every 50 hours)
• Lubricate front steering spindles, wheel bearings and axle pivot
IMPORTANT: If you operate mower in extreme heat, dust or other severe conditions, service
more often than shown below.
Service to be Performed
Intervals in Hours
Before
Each Use
Every
25
Every
50
Every
100
Every
200
Yearly
Test safety systems
X
Check fuel level
X
Check engine oil level
X
In severe conditions lubricate all mower spindles
X
In severe conditions check and clean
engine air cleaner
X
Check tire pressure
X
Check cutting height
X
Check/tighten hardware
X
Change engine oil
X
Change engine oil filter
X
Change/clean engine air cleaner pre-cleaner
X
Change/clean engine air cleaner cartridge
X
Replace fuel filter
X
Lubricate mower spindles
X
Clean battery
X
Lubricate front steering spindles, wheel bearings
and axle pivot
X
Check automatic transmission oil level
X
Replace spark plugs
X
Clean cooling shrouds and cooling areas
X
