Sabio CM1, Руководство по установке

Страница: 14 / 53

Use this mode if you want the main
network connection to be the wireless
interface. You will still need to leave the
CM1 plugged into your network using
an Ethernet cable for the setup phase of
the configuration.
1. Turn the CM1 off, change the “network se
lection switch” located on the back of the
CM1 to “Client Scan”
(figure-09)
.
2. Extend the antenna at this time, and power
the unit back on at this time
(figure-10)
.
You will need to run the CM1 Discovery utility
again to find the CM1 on the network, and log
into the CM1 as previously explained. Click on
the “System Setting” icon
(figure-11)
. The screen
showing the system status is displayed first.
CM1 can be configured as a wireless networked drive:
figure-09
figure-10