© Sabine 2007
SWM7000 Receiver & Transmitter Quick Setup
Please read Section Four Transmitter Operation and Section Five Receiver Operation of the operating guide for
a complete understanding of how to set up your Sabine 2.4 GHz Smart Spectrum
®
True Mobility
®
System. See page
4 of this Quick Start Guide for tips on channel selection and maximizing RF performance.
4
a.
Power ON
Open battery/control door
c.
b.
Select
RF channel function
Select
RF channel
Switch
SELECT
POWER ON & SET TRANSMITTER
CONNECT RECEIVER
Connect the receiver output (¼-inch or XLR jack) to the
mic or line input of your mixer or amplifier.
Mixer balanced
input (XLR)
Mixer balanced
or unbalanced
input (TRS/TS)
2
1
RECEIVER & TRANSMITTER CHANNEL SELECTION
ANTENNA POSITION
1
Transmitter range is 100
meters line-of-sight
2-Ch receivers only:
Press Channel Select/Contrast
button to edit receiver channel
POWER ON RECEIVER & SELECT RF CHANNEL
3
b.
Power ON
a.
Set Level:
Mic: Less than 0
Line: Less than -15
d.
Select RF channel
c.
SET INPUT (SW75-T ONLY) / ADJUST PAD
or LO CUT SETTINGS
(if necessary)
5
N
O
C
UT
c.
Select
LO CUT setting
C
UT
AT
75 H
Z
a.
Select Input
SW
75-T
BELTPACK
TRANSMITTERS
ONLY
SELECT
Adjust PAD if audio extends
into Clipping Zone
SELECT
b.
1. Select
PAD function
2. Select
PAD setting
It is best to keep the system’s channels close together at the low
or high end of the spectrum, i.e. channels 1, 2,3,4,5 or channels 65,
66, 67, 68. If there is another 2.4 GHz source in the room, grouping
the channels reduces the chances of an overlap. Do not start by spread-
ing your channels throughout the 70 channel range of the system --
you are more likely to encounter interference this way. See step 3 for
the controls used to select RF channels.
UP
DOWN
SELECT
