SABINE FBX2410 Скачать руководство пользователя страница 10

10

Warning! This equipment must be earthed. 

Caution! Risk of electric shock. Do not open.

Caution! Shock hazard. Do not remove covers. No user serviceable 

parts inside. Refer servicing to qualified service personnel. 

Warning! To reduce the risk of fire or electric shock, do not expose this 

product to rain or moisture.

Attention! Cet appareil doit être relié à la terre.

Attention! Risque de choc électrique; ne pas ouvrir.

Attention! Risque de choc; ne pas oter les capots. Aucune pièce acces-

sible à l'intérieur. S'addresser à un technicien qualifié.

Attention! Pour réduire le risque d'incendie ou de choc électrique, ne 

pas laisser l'appareil sous la plouie ou à l'humidité.

Achtung! Dieses Gerät muss schutzgeerdet sein.

Achtung! Gefar eines elektrischen Stormschlags. Gehause nicht öffnen.

Achtung! Gefar eines elektrischen Stormschlags. Gehäuse nicht öffnen. 

Keine con Benutzer zu bedienenden Teile im Geräteinneren.

Überlassen Sie das Gerät zu Servicezwecken nur geschultem Fachper-

sonal.

Um Brandgefar oder das Risiko eines elektrischen Schlags 

auszuschließen, das Gerät vor Nässe und Feuchtigkeit schützen.

Advertencia! Este equipo debe estar conectado a tierra.

Precaución! Reisgo de descarga eléctrica. No abrir.

Precaución! Riesgo de descarga eléctrica. No desmontar las tapas. 

Piezas interiores no reparables por el usuario. Reparable sólo por 

personal cualificado.

Advertencia! Para reducir el riesgo de incendio o de descarga eléctrica 

no exponga este producto a la lluvia o humedad. 

FCC Statement:

This device complies with Part 15 of the FCC Rules.  Operation is subject 

to the following conditions: (1) This device may not cause harmful interfer-

ence; and (2) This device must accept any interference received, including 

interference that may cause undesired operation.  

Warning: 

Changes or 

modifications to this unit not expressly approved by the party responsible 

for compliance could void the user's authority to operate the equipment.

NOTE: This  equipment  has  been  tested  and  found  to  comply  with  the 

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  

These limits are designed to provide reasonable protection against harmful 

interference in a residential installation.  This equipment generates, uses, 

and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio 

communications.  However, there is no guarantee that interference will not 

occur in a particular installation.  If this equipment does cause harmful 

interference to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to try to correct 

the interference by one or more of the following measures:

 

• Reorient or relocate the receiving antenna.

 

• Increase the separation between the equipment and receiver.

 

• Connect the equipment into an outlet on a circuit different  

 

  from that to which the receiver is connected.

 

• Consult the dealer or an experienced radio TV technician for 

help.

Canadian Compliance Statement

This digital apparatus does not exceed the Class B limits for radio noise 

emissions from digital apparatus set out in the Radio Interference Regula-

tions of the Canadian Department of Communications.

Le  present  appareil  numerique  n'emet  pas  de  bruits  radioelectriques 

depassant les limites applicables aux appareils numeriques de la class B 

prescrites dans le Reglement sur le brouillage radioelectrique edicte par 

le ministere des Communications du Canada.

Japanese EMI  Compliance Statement

The FBX2410 Series is designed to operate from standard AC power. 

Please be sure the power in your area is compatible with the power 

requirements marked on the rear of the unit. Using the wrong input 

voltage may cause permanent damage to the unit and will void the 

warranty. 

The FBX2410 Series is supplied with one of the following AC power 

cords:

Japan 

 

 

100 VAC

U.S./North America  

120 VAC

Continental Europe   

230 VAC

United Kingdom 

 

240 VAC

Australia   

 

240 VAC

1. 

Read  all  safety  and  operating  instructions  before  using  this  prod-

uct. 

2. 

All  safety  and  operating  instructions  should  be  retained  for  future 

reference.

3. 

Obey all cautions in the operating instructions and on the unit.

4. 

All operating instructions should be followed.

5. 

Use only shielded audio and data cables.

6. 

This product should not be used in the presence of moisture or rain, 

or near any water, i.e., a bathtub, sink, swimming pool, wet basement, 

etc.

7. 

This product should be located so that its position does not 

  

interfere with proper ventilation. Do not use in direct sunlight.  Do not 

place flat against a wall or in a built-in enclosure that will impede the 

flow of cooling air.

8. 

This product should not be placed near a source of heat such as a 

stove or radiator.

9. 

Connect only to a power supply of the type marked on the unit adjacent 

to the power entry module.

10.  Never break off the ground pin on the power supply cord.
11.  Power supply cords should always be handled carefully. Never walk 

or place equipment on power supply cords.   Periodically check cords 

for cuts or signs of stress, especially at the plug and the point where 

the cord exits the unit.

12.  The power supply cord should be unplugged when the unit is to be 

unused for long periods of time.

13.  Care should be taken so that objects do not fall and liquids are not 

spilled into the unit through the ventilation holes or any other open-

ings.

14.  This unit should be checked by a qualified service technician if:
 

A. The power supply cord or plug has been damaged.

 

B. Anything has fallen or been spilled into the unit.

 

C. The unit does not operate correctly.

 

D. The unit has been dropped or the enclosure damaged.

15.  The user should not attempt to service this equipment. All 
 

service work should be done by a qualified service technician.

OSHA 2201; 19

95 revised.

Caution!

Replace the fuse with a fuse of exactly the same rating 
specified on the rear of the product.

SeCtIon eIGHt — CAUtIonS & wArrAntY

Warning!

Содержание FBX2410













Отзывы: