SABER Power BDS6X9, Руководство по эксплуатации

Страница: 7 / 14

SAVE THESE INSTRUCTIONS
Sanding belt replacement
Repeat the same procedure as in Fig. 4. Loosen the
belt and take the old belt out. After replaced a new
belt, make sure that the belt has its proper tension.
Refer to Fig. 5.
Sanding disc paper and V-belt replacement
1. Loosen the knob and open the disc cover as
shown in Fig. 6.
2. Tear off the old sanding papers, clean off
the glue remain on the disc and put on the new
sanding paper as Fig.7
3. Use the alien wrench as shown in Fig 8.
insert the wrench in the rectangular window
opened at the bottom of the disc cover.
Loosen the set screw inside and take off the
sanding disc. When you are going to put the
disc back, remember that the set screw' must
mount on the flatness side of the shaft and
tighten.
Adjustment of table from 0°- 45°
Loosen the knob and adjust the table till it
reach the scale you demand (varies from 0° -
45°) and tighten.
Fig. 6
Fig. 5
Fig. 7
Fig. 8
Fig. 9