Safety Tips
Before opening LP cylinder valve, check the coupling nut for
tightness.
When grill is not in use, turn off all control knobs and LP
cylinder valve.
Never move grill while in operation or still hot.
Use long handled barbecue utensils and oven mitts to avoid
burns and splatters.
Maximum load for sideburner and side shelf is 10 lbs.
The grease tray
must
be inserted into grill and emptied after
each use. Do not remove grease tray until grill has
completely cooled.
Clean grill often, preferably after each cookout. If a bristle
brush is used to clean any of the grill cooking surfaces,
ensure no loose bristles remain on cooking surfaces prior to
grilling. It is not recommended to clean cooking surfaces
while grill is hot.
If you notice grease or other hot material dripping from grill
onto valve, hose or regulator, turn off gas supply at once.
Determine the cause, correct it, then clean and inspect valve,
hose and regulator before continuing. Perform a leak test.
Keep ventilation openings in cylinder enclosure (grill cart)
free and clear of debris.
Do not store objects or materials inside the grill cart
enclosure that would block the flow of combustion air to the
underside of either the control panel or the firebox bowl.
The regulator may make a humming or whistling noise during
operation. This will not affect safety or use of grill.
If you have a grill problem see the
“Troubleshooting Section”.
If the regulator frosts, turn off grill and LP cylinder valve
immediately. This indicates a problem with the cylinder and
it should not be used on any product. Return to supplier!
CAUTION
If ignition does NOT occur in 5 seconds, turn the
control knobs OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
CAUTION
Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety reasons.
Do not use water on a grease fire. Personal injury may
result. If a grease fire develops, turn knobs and LP
cylinder off.
Do not leave grill unattended while preheating or
burning off food residue on
HI
. If grill has not been
regularly cleaned, a grease fire can occur that may
damage the product.
Main Burner Match-Lighting
Do not lean over grill while lighting.
1. Turn
OFF
all control knobs.
2. Turn
ON
gas at LP cylinder.
3.
Open lid during lighting.
4. Place match into match holder (hanging from left side of cart).
Light match, place into lighting hole on left side of firebox.
5. Push in and turn far left control knob to position. Once
burner has ignited (use flame viewing ports to verify), turn
control knob to desired setting.
6. If ignition does
NOT
occur in 5 seconds, turn the control knob
OFF
, wait 5 minutes, and repeat the lighting procedure.
7. Light adjacent burners in sequence by pushing control knob
in and turning to position.
Main Burner Ignitor Lighting
Do not lean over grill while lighting.
1. Turn
OFF
all control knobs.
2. Turn
ON
gas at LP cylinder.
3.
Open lid during lighting
.
4. To ignite, push and turn burner control knob to
5. Push and hold
ELECTRONIC IGNITION
button until the burner
lights (use flame viewing ports to verify).
6. If ignition does
NOT
occur in 5 seconds, turn the burner controls
OFF
, wait 5 minutes, and repeat the lighting procedure.
7. Ignite remaining burners by repeating steps 4 through 6 for each
burner.
8. Once each burner has ignited, turn knobs to desired setting.
Viewing ports
7
Sideburner Ignitor Lighting
Do not lean over grill while lighting.
1. Turn
OFF
all control knobs.
2. Turn
ON
gas at LP cylinder.
3.
Open sideburner lid during lighting
.
4. To ignite push in and turn side burner control knob to .
5. Push and hold
ELECTRONIC IGNITION
button until the burner
lights (use flame viewing ports to verify).
6. If ignition does
NOT
occur in 5 seconds, turn the control knobs
OFF
, wait 5 minutes, and repeat the lighting procedure.
7. Repeat steps 4 through 6 for second burner.
