Saber Compact R50CC0317, Руководство по эксплуатации продукта

Страница: 9 / 60

Firebox
Carryover tube
Electrode
Firebox burner
bracket
Pry off electrode with a fl at
blade screwdriver
Retainer clip
9
Correct
burner-to-valve
engagement
Storing your grill
·
Clean cooking grates.
·
Store in dry place.
·
When LP cylinder is connected to grill, store outdoors in a
well ventilated space and out of reach of children.
·
Cover grill if stored outdoors. Choose from a cover offered
by the manufacturer.
·
Store grill indoors ONLY if LP cylinder is turned off and
disconnected, removed from grill and stored outdoors.
·
When removing grill from storage, follow “ Cleaning the
Burner Assembly” instructions before starting grill.
CAUTION
CONTROL PANEL
SPIDER ALERT!
SPIDER AND WEBS
INSIDE BURNER TUBE
VALVE
SPIDER WEBS
BURNER
INSIDE BURNER
CONTROL PANEL
If you notice that your grill is getting hard to light or that the
fl ame isn’t as strong as it should be, take the time to check and
clean the burners.
In some areas of the country, spiders or small insects have been
known to create “
fl ashback” problems. The spiders spin webs, build
nests and lay eggs in the grill’s burner tube(s) obstructing the fl ow of
gas to the burner. The backed-up gas can ignite in the burner
behind the control panel. This is known as a
fl ashback and it can
damage your grill and even cause injury.
To prevent fl ashbacks and ensure good performance the burner
assembly should be removed from the grill and cleaned before use
whenever the grill has been idle for an extended period.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1. Turn gas
to OFF at control knobs and gas source.
2. Remove cooking grates and emitters.
3. Remove retaining clips and carryover tubes from rear of
burners.
4. Using a
flat blade screwdriver pry off the electrode from each
burner. Electrode should remain in burner box connected to
ignition wire .
5. Carefully lift each burner up and away from valve openings.
6. We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well) into
a small hook. Run the hook through each burner tube
several times.
(B) Use a narrow bottle brush with a fl exible handle (do not use
a brass brush), run the brush through each burner tube
several times.
(C) Wear eye protection: Use an air hose to force air into the
burner tube and out the burner ports. Check each port to
make sure air comes out each hole.
7. Wire brush entire outer surface of burner to remove food
residue and dirt.
8. Clean any blocked ports with a stiff wire such as an open paper
clip.
9. Check burner for damage, due to normal wear and corrosion
some holes may become enlarged. If any large cracks or holes
are found replace burner.
10.Re-attach electrode to burner. Ensure ignition wire is
connected.
11.Carefully replace burners. VERY IMPORTANT : Burner tubes
must re-engage valve opening.
12.Re-attach burners to brackets inside burner box.
13.Reposition carryover tubes and re-attach to burners.
14.Replace emitters and cooking grates.
Cooking surfaces: If a bristle brush is used to clean any of the
grill cooking surfaces, ensure no loose bristles remain on cooking
surfaces prior to grilling. It is not recommended to clean cooking
surfaces while grill is hot.