DANGER
DANGER:
Before the refrigerator is used, it must be
properly positioned and installed as described in this
manual, so read the manual carefully. To reduce the risk
of fire, electrical shock, or injury when using the
refrigerator, follow these precautions:
• Plug into a grounded, 3-prong outlet, do not remove
grounding prong, do not use an adapter, and do not use an
extension cord.
• It is recommended that a separate circuit, serving only your
refrigerator be provided. Use receptacles that cannot be
accidentally turned off by a switch or pull chain.
• Never clean refrigerator parts with flammable fluids. Fumes
can create a fire hazard or explosion. Do not store or use
gasoline or other flammable vapors and liquids in the vicinity
of this or any other appliance. The fumes can create a fire
hazard or explosion.
• Before proceeding with cleaning and maintenance
operations, make sure the power cord of the unit is
disconnected.
• Do not connect or disconnect the electric plug when your
hands are wet.
• Unplug the refrigerator or disconnect power before cleaning
or servicing. Failure to do so can result in electrical shock or
death.
• Do not attempt to repair or replace any part of your
refrigerator unless it is specifically recommended in this
manual. All other servicing should be referred to a qualified
technician.
• Use two or more people to move and install refrigerator.
Failure to do so can result in serious injury.
• To ensure proper ventilation for your refrigerator, the front of
the unit must be completely unobstructed. For proper
operation, choose a well-ventilated area with temperatures
above 40°F (5°C) and below 105°F (40°C). This unit should
be installed in an area protected from the direct elements,
such as wind, rain, and direct sunlight. See Island Enclosure
Guidelines for details.
• The refrigerator should not be located directly next to ovens,
grills or other sources of high heat.
• The refrigerator must be installed with all electrical, water
and drain connections in accordance with state and local
codes.
• A standard electrical supply
(115 V AC only, 60 Hz)
, properly
grounded in accordance with the National Electrical Code
and local codes and ordinances is required.
• Do not crimp or pinch the power supply cord of refrigerator.
• The circuit breaker size should be 15 amps.
•
It is important for the refrigerator to be leveled in order
to work properly.
You may need to make several
adjustments to level it.
• Installation must be in accordance with local plumbing code
requirements.
• Never allow children to operate, play with, or crawl inside the
refrigerator.
• Do not use solvent-based cleaning agents or abrasives on
the interior. These cleaners may damage or discolor the
interior.
• Do not use this apparatus for other than its intended
purpose.
Placement and Location
•
Place your unit on a floor that is strong enough to support
the unit when it is fully loaded. To level your unit, adjust the
leveling legs at the bottom of the unit.
•
Locate the unit away from direct sunlight and sources of
heat (stove, heater, radiator, etc.). Direct sunlight may affect
the acrylic coating and heat sources may increase electrical
consumption.
•
Ambient temperatures less than 40
°
F (5
°
C) may cause the
unit not to perform properly.
•
Plug the unit into an exclusive, properly installed, grounded
wall outlet. Do not under any circumstances cut or remove
the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed
toward a certified electrician.
•
After plugging the appliance into a wall outlet, allow the unit
to cool down for 24 hours before placing food in the
refrigerator compartment.
Island
enclosure
guidelines
24.00”
21.25”
33.75”
Minimum
Dimensions -
Inches
BACK
>7 7/8”
LEFT
>4”
RIGHT
>4”
TOP
>4”
Minimum Clearances:
Grill Opening
6.00” minumum
3
