Assembly and operating manual
rtv.sabaj.pl/en/home/
b.
Aiming your remote towards the IR-Receiver, press
5 buttons
you want to use for
controlling the unit. Every properly acquired signal will be confirmed by a number of
short "beep" signals. Please allow the number of beeps corresponding to a function
below to finish sounding, before pressing another button. Number of signals
correspond to the button set:
(I)
–
closing button
(1 constant signal)
(II) -
opening
(2 s constant signal)
(III)
–
setup button
(3 s constant signal)
(IV)
–
preferred position button
(4 s constant signal)
(V)
–
close button
(5 s constant signal)
After the last signal sounds, constant beep is off and the remote control is programmed.
NOTE:
Remember that these buttons will also be active for device supported until now by the
remote
.
The mount cannot be operated by more than one remote control. remotes (fig. 12
–
example settings).
fig.11
fig.12
