10
To assign IR remote control the following steps must be carried out:
• Connect the IR-Eye to the left back side
• Press and hold SETUP button (blue) for about 3 seconds until you hear a beep and the red indicator
SETUP will light up. Now you are in setup mode.
• Select a button on your IR remote control which you would like UP movement. Point the remote at the IR
receiver and press the selected button. Red Power LED dims once, acknowledging receipt of the signal from
your remote control
• Select a button on your IR remote control, which would like to use for DOWN movement. Point the
remote at the IR receiver and press the desired key. Red power LED dims twice, acknowledging receipt of
the signal from your remote control
• Press and hold SETUP button (blue) for about 3 seconds until you hear two beeps and the SETUP light
goes off. Your IR remote control has been registered.
RF Remote Control assignment
The supplied RF remote is already programmed with your TV-Lift . In case you want to program a new
one , follow these steps :
-
Press& hold the RC Set button for about 3 seconds
-
The lift will wait for any signal from a remote for 15 seconds from now on
-
Press any button on your remote
The lift will acknowledge the new remote, which will now be operative
Note: The Control Box has a memory of 8 Remotes. If you will want to program the 9
th
remote control – the
1
st
will be deleted
Digital Display
The control box is equipped with the Digital Display, which helps to maintain the lift or identify the problem
during the installation. (The control box monitors the energy consumption of your lift. After exceeding
allowed current of motor (allowed load of lift) control box cuts the power out and lift stops. After the
obstacle is removed the lift can operate normally.
Display messages
„0” Blinking – electric motor overload (current exceeded)
„3” Blinking – wiring loom not connected to the control box
„4” Blinking – lower limit switch activated
„5” Blinking – upper limit switch activated
Pressing any button will delete the display message.
