Assembly and operating manual
rtv.sabaj.pl/en/home/
21.
Reset settings:
It is possible to reset all the favorite positions. To reset the lift press & hold
SETUP button for about 5 seconds. Control box will confirm resetting by short "beep" signal
and showing you this symbol on the digital display:
After resetting the lift, it will move
substantially slower until it will reach the marginal positions, to calibrate itself.
NOTE:
If you reset the settings, please drive the lift to its lowest position, move it up and rotate at
least 45° left and 45° right. Skipping this step may result in the lift tilting.
22.
Troubleshooting:
The table of symbols on the digital display should also be used as a
troubleshooting guide. Always check, if the green POWER led light is on
– this signals,
that the control box is powered. When you put the plug to the socket, you will hear the
beeper sound, and the green led will be turned on. If the LED is not on, the problem might
be with the control box fuse breakdown, or there is no power in the socket.
Display
Explanation
Solution
Assigning RF remote to
control box
Press any button on RF remote to assign, or
wait 15 seconds to quit mode
Assign IR remote to control box
Press I ,II , III , IV , V consequently to program
Safety system activated
Remove obstacles from the lifts way.
Eventually reduce the safety system sensivity
LIFT Limit switch cable
harness disconnected
Check all the connections and contacts from
Lift to control box. Some pins might be loose
due to transport of furniture fitting
Attempt on setting DOWN
VP position before the
DOWN limit switch.
Use this option only intentionally. It is not
recommended to set DOWN VP higher than
where the limit switch is located.
Attempt on setting UP VP
lower than DOWN VP.
Re-set the UP/DOWN settings. This might make
the lift unable to move up or down.
Down VP Memory approved
-------
UP VP Memory approved
-------
