GB
Installation
Use
•
This appliance is designed to operate in ambient temperature between 16°C and 38°C� If these
temperatures are exceeded, i�e� colder or warmer, the appliance will not operate correctly� If the
ambient temperatures are exceeded for long periods, the temperature in the fridge will rise and
food spoilage may occur�
•
Remove all packaging materials from the appliance� Wash the inside of the cabinet with
lukewarm water and bicarbonate of soda (5ml to 0�5 liter of water)� Dry the appliance
thoroughly�
Position the appliance and allow it to stand for two to three
hours before it is turned on for the first time to allow the system
to settle� Do not position next to any heat source e�g� cooker,
boiler or in direct sunlight etc�
Allow at least 10 cm of space at the top and 10 cm of space
on both sides of the appliance and between the back of the
appliance and the wall for adequate air circulation� The appliance
is not designed for recessed installation (“building in”)�
Install on a good firm level surface, and any unevenness of the
floor should be corrected prior to installation, slight unevenness
can be overcome by adjusting the front feet�
NOTE:
If the appliance is positioned on a carpet, soft floor
covering you should readjust the front feet once the appliance
has had time to settle�
In order to help you get the correct adjustment of your device, it is equipped with a temperature
gauge placed in the coldest area�
For the proper storage of food in your refrigerator and in particular in the coldest area, make sure
that «OK» appears in the temperature indicator�
TEMPERATURE INDICATE
The symbol on the left side indicates the location of the coldest area of your
refrigerator� It defines the height of this area�
If «OK» is not displayed, the average temperature in this area will be very high�
You ought to adjust the thermostat to a colder setting�
The refrigerator is controlled with a thermostat knob located inside the fridge, towards the upper
right-hand corner� Turn the knob from the STOP (OFF) position towards the higher numbers for colder
temperatures� The knob can be adjusted from setting MIN to MAX�
Changes of the ambient temperature affect temperature in the interior of the appliance so choose
a correct setting of the temperature control knob, depending on your ambient conditions�
In the STOP (OFF) position the appliance does not operate (the cooling system is switched off),
but power supply is not interrupted�
Set the thermostat knob to a middle position to get 4 to 6°C in the fridge�
Please Note:
If the appliance is switched off you must wait at least 5 minutes before restarting the appliance
or re-inserting the plug into the wall outlet� This is to allow the protection device in the compressor
to reset�
If the compressor fails to start correctly remove the plug and wait for 5 minutes before you try again
then the compressor should restart normally�
The storage temperature may be affected by:
– The room temperature
– How often the door is opened
– How much food is stored
– Position of the appliance
When you set the correct temperature, all these factors mentioned above shall be taken into account�
SETTING THE THERMOSTAT KNOB
25
24
GB
Содержание MP246WDW
Страница 1: ......
