
Automatic Backflush Filter F450
State:
05.02.2016
– 1.3
Georg Schünemann GmbH, Bremen
1-5
1.3
Accident prevention rules
1.3.1
General
After assembly (new installation or assembly after transport) and before initial
operation of the filter a safety check must be carried out. All machine parts are to
be examined for their perfect condition.
Check the filter for operational safety before setting into operation (see chapter
4.4
„Steps for setting into operation“)!
The following safety instructions are to be respected in addition of already valid
national rules for the prevention of accidents and laws!
Pay attention to the instructions in this manual and the generally valid, local safe-
ty regulations and rules for accident prevention!
Attached warning and signs give important notes for safety operation. Pay atten-
tion to the warnings.
The staffs carry the responsibility for their own security and the security of third in
the work area. This responsibility cannot be delegated!
Any malfunction possibly impairing the safety must be cleared immediately!
Defective components have to be replaced immediately!
1.3.2
Assembly and disassembly
During assembly/disassembly only the staff, necessary for it, may stay in the
work area of the filter.
Pay attention to sufficient free space of motion and stability of the ground.
Check that after the assembly all components were duly added (control for tight-
ness).
Check that all cables and connecting lines are attached to the points planned for
it!
Before initial operation of the automatic backflush filter F450 the operating per-
sonnel have to convince itself of the faultless state by prescribed controls.
1.3.3
Transport/Location
Absolutely consider the transportation and attitude information.
Before the transport of the filter the components are to be packed in an appropri-
ate and careful way.
Check and fasten the transport locks!