35
Appendix 3_EMC
SHOOKA AED is intended for use in the electromagnetic environment specified below.
The customer or the user of device, should ensure that it is used in such an environment.
Warning
Guidance and manufacturer's declaration – SHOOKA emissions
The SHOOKA is intended for use in the electromagnetic environment specified below. The customer or the user of
the SHOOKA, should assure that it is used in such an environment.
Emissions test
Compliance
Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1
The SHOOKA AED uses RF energy only for its
internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference
in nearby electronic equipment
RF emissions
CISPR 11
Class B
The SHOOKA is suitable for use in all
establishments.
Harmonic emissions
IEC 61000-3-2
N.A
Voltage fluctuations/ flicker
emissions
IEC 61000-3-3
N.A
Guidance and manufacturer's declaration – electromagnetic immunity
The SHOOKA is intended for use in the electromagnetic environment specified below. The customer or the user of
the SHOOKA should assure that it is used in such an environment.
Immunity test
Port
Compliance level
Electromagnetic environment -
guidance
➢
Use only the recommended manufacturer accessory. Using the accessory other than
in relevant chapter may cause to increase the EMISSION or decrease the
IMMUNITY of system.
➢
Measurements can be affected by mobile and RF communications equipment. It
should be assured that the AED is used the electromagnetic environment specified.
➢
To prevent EMC effect on the AED, the system should not be used adjacent to or
stacked with other equipment and that if adjacent or stacked use is necessary, the
equipment should be observed to verify normal operation in the configuration in
which it will be used.
➢
It is suggested to use another sensitive device in distance with the AED.
