32 025 690 7
Saab 9-5 5D M06-
36 Attach the ground cable to the grounding point
in the luggage compartment below the left-hand
tail lamp.
37 Run the thicker section of the wiring harness
against the left-hand wheel housing and the
thinner section along the luggage compartment
sill to the right-hand side of the car.
38 Plug the connector into the provision for the tow-
bar wiring harness.
Cars with towbar:
Unplug the connectors and
plug both wiring harness connectors into them.
39 Plug in the wiring harness connector to the pro-
vision for the CD changer and fit the blind plug
to the SPA harness connector. Affix anti-rattle
tape and secure with a cable tie to avoid rattle.
At the seatbelt, the wiring harness must be
routed to the right and follow the wheel housing.
Cars with CD changer:
Unplug the connectors
and plug each wiring harness connector into
them. Affix anti-rattle tape and secure with a
cable tie to avoid rattle.
40 Connect the wiring harness to the control mod-
ule and mount the control module on the floor.
Tighten the plastic nuts.
41 Use cable ties (x18) to secure the wiring har-
ness along its entire route. Gather excess wiring
harness and secure it above the wheel housing.
A Cable tie for fitting on weld screw.
B Cable tie with clip for fitting in holes
E930A390
41
36
41
38
41
40
41A
41B
41A
41 41
41
39
41
41
WARNING
Check that the wiring harness is not pinched.
Incorrect fitting can damage the wiring harness
and cause a short-circuit/fire.
