4 32 025 682
Saab 9-3 5D M06-
1 Connect the diagnostic tool and separate the
infotainment system's control panel and radio
from the car.
2 Remove the key from the ignition switch.
3 Remove the infotainment system control panel.
4 Fit a new infotainment system (ICM3) control
panel.
5 Remove the radio.
6 Fit the kit's radio.
7
On cars with TEL1:
Fit the microphone in the
roof console's vacant space on the passenger
side.
– The connector is located by the microphone
for the driver's side.
– Remove the tape over the hole for the
microphone.
Note
For more detailed information on the different
steps in the removal/fitting methods, please refer
to the corresponding section in WIS.
Important
The control module is sensitive to electrostatic dis-
charges. To avoid damaging the internal compo-
nents in the control module, a replacement must
be made with care in the following way:
·
Never touch the pins on a control module with
hands or clothes.
·
Ground yourself by touching the car's body/
engine. Remove the connector on the car's
control module.
·
Ground yourself by touching the car's body/
engine. Connect the connector on the car's
control module.
·
Deposit the replaced control module in the
returns packaging without touching its pin.
·
Keep the new control module in its packaging
as long as possible.
F930A449
7
7
5,6
Important
Handle the fibre-optic cables with care or the sig-
nal may be distorted.
·
Do not bend the cable in a radius smaller than
25 mm.
·
Do not expose the cable to impact as this may
cause the transparent plastic to whiten,
thereby reducing the intensity of the light and
causing possible communication interruptions.
·
The cable should not lie against any sharp
edges as this may cause increased signal
reduction.
