32 025 682 11
Saab 9-3 5D M06-
39 Locate the loose fibre optic cable, and the con-
nector with the fibre optic cables connected, by
the left-hand lower A-pillar (taped to the cable
duct).
40 Lift up the connector lock tab.
41 Remove the fibre optic cable from the position in
the connector where the arrow points outwards,
to the fibre optic cable.
42 Remove the fixing tape from the loose fibre optic
cable.
43 Remove the protective cover from the
connection.
44 Fit the protective cover onto the removed fibre
optic cable connection and carefully move the
fibre optic cable aside in order to prevent dam-
age, and position it behind the wiring harness.
45 Fit the loose fibre optic cable in the connector
and fit the lock tab.
46 Fit the A-pillar trim.
47 Fit the scuff plate.
48 Set the seat in its correct position, be careful that
the fitting hooks locate themselves correctly into
their mountings, and fit the rear retaining
screws.
Tightening torque 30 Nm (22 lbf ft)
Important
Handle the fibre-optic cables with care or the sig-
nal may be distorted.
·
It is very important that the two leads in the
connector are not confused with one another.
·
Do not bend the cable in a radius smaller than
25 mm.
·
Keep the cable ends free from dirt and grime.
·
The cable should not lie against any sharp
edges as this may cause increased signal
reduction.
F930A456
40
39
39
41
