INSTALLATION MANUAL
T7 DIVING SYSTEM™
9
srsmith.com
TIP: Make sure to use the anti-seizing compound on all the bolts or the nuts will seize.
1. Lay board upside down on packaging being careful not to damage the gel coat surface.
2. Place T7-NSPRING over the 8 bolts on the board as shown in photo below.The single center drill hole in the spring center faces
toward the pool. Use hardware kit T7-102-SS and attach the springs to board as shown in exploded view in page 11. Hand
tighten only at this time.
TIP: The springs are directional. The longer end of the spring goes toward the pool.
STEP 2: T7 ASSEMBLY:
3.
Board Fall (optional) Board
If installing a Board Fall waterfall, run the hose through
the board as shown in photo. Use the 4 screws provided
with the Board Fall unit to attach to bottom of board.
4.
Board Fall (optional) Base
If installing the Board Fall waterfall, remove the hole black
cap on the base by pushing it out from the underside. Do
not try to remove from the top as damage to the gel coat
surface can occur.
See arrow reference in photo shown.
