11
3.50
SLIDE EXIT ALIGNMENT
POOL EDGE
LINE
8.89
MANUFACTURER’S PLACEMENT INSTRUCTIONS
PROPER ASSEMBLY, INSTALLATION, USE,
AND SUPERVISION ARE ESSENTIAL FOR
PROPER OPERATION AND TO REDUCE RISK
OF SERIOUS INJURY.
1.
The critical dimensions for placement of the
SlideAway are shown in
Figures 13
,
14
and
15
.
A. The red lines on the sides of the runway
exit must be aligned with, or overhanging
the pool edge, see
Figure 13
.
SLIDE SETUP INSTRUCTIONS
1.
Place the assembled slide on the deck in a location that meets the requirements detailed in Manufacturer’s
Placement instructions on pages 13, 14 and 15. The Slide may be angled slightly providing all dimensions
are maintained as noted in the Manufacturer’s Placement Instructions.
The red lines on the sides of the
runway exit warning label must be aligned with, or overhanging the edge of the pool (Figure 13).
2.
Once the slide is in the proper location on the deck, the support brace must be installed and the
ladder must be filled with water to provide stability to the slide prior to use.
3.
Insure proper installation of the support brace as instructed in
Slide Assembly Instructions
on page 10
(see
Figures 6
and
7
). The support brace must be installed prior to filling the ladder with water.
4.
The slide must not be used unless the ladder is filled with water up to the minimum fill line, see Figure
12.
5.
Install the plug (4) into the drain hole shown in
Figure 12
.
It is recommended to use a thread sealant or Teflon tape
on the threads to prevent leaking. To fill the ladder with
water, remove the fill cap (3) by turning counter clockwise
and pulling outward to remove. Remove the cap and
fill ladder base with water up to the minimum fill line.
Replace the cap by inserting into the hole and turning
clockwise to lock into place.
6.
Once the ladder is filled with water the slide cannot be
moved. To remove the water from the ladder, unscrew
the plug and allow to drain.
Figure 12
Figure 13
