79-15159-00 REV B2 9.14
www.srsmith.com
Page 3 of 6
9.
Glue into place all conduit pipes at this time. It is recommended that all fiber optic conduits
be no less then ¾” in diameter and that the 12VAC conduit for the wire on the Color Light
Stream LED driver be no less then ¾”. It is highly suggested that you install all fiber conduit
with sweep fittings for easy fiber installation.
10.
Fill excavated area with gravel until the gravel reaches approximately 1” up on the bottom of
the deck box.
11.
Finish your deck material installation making sure that the Color Light Stream™ Deck Box
lid remains level. Utilizing the 3” adjustable Deck Flange on the deck box, adjust to match
your deck height.
12.
At this time run the supplied 100ft of 12VAC wire from the Color Light Stream LED driver
through your conduit, back to the location of your transformer.
13.
Run all fiber cable through their respective conduits to the Color Light Stream Mini Deck
Box.
14.
Fill all conduit connections inside the Color Light Stream Deck box with silicone or similar
materials to prevent water from entering deck box interior.
15.
Make wire connections per your UL Listed Outdoor Rated Class 2 transformer manufacturers
directions. All wiring must be in compliance with local electrical codes and NEC.
Typical Results
Results based upon 40ft at 1 ½ PVC water supply pipe and 6” under water.
42 GPM – From 12 inches above water level
55 GPM – From 16 inches above water level
75 GPM – From 30 inches above water level
FIBER PORT INSTALLATION
Remove Color Light Stream LED driver
from bracket by unscrewing the mounting
screw and sliding the LED driver from the
bracket.
Mounting Screw
NOTE: LIGHTING EFFECT IS ONLY 10-12 INCHES MAXIMUM
NOTE: LIGHTING EFFECT IS ONLY 10-12 INCHES MAXIMUM
