S-COM 7K, Руководство пользователя, Страница: 190 / 400

7K
•
Chapter 11
11-8
Select DTMF Decoder Mute Delay
Sets the amount of muting that occurs after a DTMF digit is
received by the controller.
•
Enter one digit representing the delay duration; 0.0 through 0.9 seconds.
Command Form:
Command Form Data Digit
Select DTMF Decoder Mute Delay (PW) 96 x * (0–9) =
(0.0–0.9) seconds
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: DTMF Decoder Mute Delay is 0.5 seconds
Examples:
When a DTMF digit is recognized by the controller, it mutes the audio so that
the digit is not re-transmitted. Since some time is required by the controller to
decode the digit, a short burst of tone is re-transmitted. A timer is started for
the purpose of delaying the muting. This allows a string of DTMF digits to be
entered, with all but the first one fully muted. The
Select DTMF Decoder Mute
Delay command shown above controls this timer.
•
If set to zero, the muting will end when the DTMF digit is released.
•
If set to 9, the muting will last 0.9 seconds beyond the release of the DTMF
digit.
Since a voice will occasionally trip the DTMF decoder, a long mute delay may
not be desired.
If a DTMF digit is held down for a continuous period of time, the controller will
stop muting after 10 seconds.
To change the mute delay to 0.3 seconds, for example, enter the following
command:
(PW) 96 3 *