Ryobi TS1343L, Руководство оператора

Страница: 27 / 30

27
ADJUSTMENTS
WARNING:
Before performing any adjustment, make sure the tool is
unplugged from the power supply. Failure to heed this
warning could result in serious personal injury.
The compound miter saw has been adjusted at the
factory for making very accurate cuts. However, some of
the components might have been jarred out of alignment
during shipping. Also, over a period of time, readjustment
will probably become necessary due to wear. After unpacking
the saw, check the following adjustments before you begin
using saw. Make any readjustments that are necessary and
periodically check the parts alignment to make sure that the
saw is cutting accurately.
CAUTION:
Do not start the compound miter saw without checking
for interference between the blade and the throat plate.
Damage could result to the blade if it strikes the throat
plate during operation of the saw.
PIVOT ADJUSTMENTS
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
TRAVEL PIVOT ADJUSTMENT
 The saw arm should rise completely to the up position
by itself.

If the saw arm does not raise by itself or if there is play in
the pivot joints, have saw repaired at your nearest RYOBI
AUTHORIZED SERVICE CENTER.
BEVEL PIVOT ADJUSTMENT

The compound miter saw should bevel easily by loosening
the bevel lock knob and tilting the saw arm to the left.

If movement is tight or if there is play in the pivot, have saw
repaired at your nearest RYOBI AUTHORIZED SERVICE
CENTER.
DEPTH STOP
The depth stop limits the blade’s downward travel. It
allows the blade to go below the miter table enough to
maintain full cutting capacities.
The depth stop is factory set to provide maximum cutting
capacity for the 10 in. blade provided with the saw. Therefore,
the saw with blade provided should never need adjustments.
POSITIVE STOP ADJUSTMENTS
See Figure 36.
NOTE: This procedure can be used to check blade squareness
of the saw blade to the miter table at both 0° and 45° angles.
These adjustments were made at the factory and normally
do not require readjustment.
To adjust:

Unplug the saw.
 Using the blade wrench, loosen the positive stop adjust-
ment screw.

Loosen the bevel lock knob by turning the knob coun-
terclockwise.
 Square the blade to the miter table as described in the
Assembly section of this manual.

Retighten bevel lock knob. Recheck blade-to-table align-
ment.
The saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicator
screws and reset them to zero.
POSITIVE STOP
ADJUSTMENT
SCREW FOR
45
°
ANGLES
POSITIVE STOP
ADJUSTMENT
SCREW FOR
0
°
ANGLES
BEVEL LOCK
KNOB
Fig. 36