Page 13
OPERATION
TO HELP MAINTAIN CONTROL:
■
Always support your workpiece near the cut.
■
Support your workpiece so the cut will be on your left.
■
Clamp your workpiece so it will not move during the cut.
Place your workpiece with its good side down.
NOTE: The good side is the side on which appearance is
important.
Before beginning a cut, draw a guideline along the desired
line of cut. Then place front edge of base on that part of your
workpiece that is solidly supported.
See Figure 13.
Never place your saw on that part of the workpiece that
will fall off when the cut is made.
See Figure 15.
Hold your saw firmly with both hands.
See Figure 16.
Depress the lock-off button and squeeze the switch trigger to
start your saw. Always let the blade reach full speed, then
guide your saw into the workpiece.
WARNING:
The blade coming in contact with the workpiece before it
reaches full speed could cause your saw to "kickback"
towards you resulting in serious injury.
When making a cut use steady, even pressure. Forcing
causes rough cuts, could shorten the life of your saw and
could cause "kickback."
DANGER:
When sawing through work, the lower blade guard does
not cover the blade, exposing it on the underside of work.
Keep your hands and fingers away from cutting area. Any
part of your body coming in contact with the moving blade
will result in serious injury.
After you complete your cut release the trigger and allow the
blade to come to a complete stop. Do not remove your saw
from workpiece while the blade is moving.
CAUTION:
To make sawing easier and safer, always maintain proper
control of your saw. Loss of control of your saw could
cause an accident resulting in possible serious injury.
45
45 50
50
30
30
22
22
45
45 50
50
30
30
22
22
RIGHT
Fig. 16
Fig. 15
WRONG
Содержание RY6200
Страница 19: ...Page 19 NOTES...
