Ryobi RWC-1350, Руководство по эксплуатации для владельца

Страница: 7 / 8

After use, check the tool to make sure that it is in top condition.It
is recommended that you take this tool to a RYOBI Authorized
Service Center for a thorough cleaning and lubrication at least
once a year.
DO NOT MAKE ANY ADJUSTMENTS WHILE THE MOTOR IS
IN MOTION.
ALWAYS REMOVE THE BATTERY FROM THE TOOL BEFORE
CHANGING REMOVABLE OR EXPENDABLE PARTS
(BIT...ETC.), LUBRICATING OR WORKING ON THE UNIT.
WARNING!
To ensure safety and reliability, all repairs should be performed by
an AUTHORIZED SERVICE CENTER or other QUALIFIED
SERVICE ORGANIZATION.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
MAINTENANCE
6
NOTE: There are several spacer washers available for you.
Ensure that the groove width is the total of the spacer washers
between the diamond cutting discs and the thickness of the
culting discs.
• Tighten the lock nut using the lock nut spanner (15). Press the
spindle lock while doing this.
NOTE: When setting a cut width that is smaller than the
maximum cut width, you must use the backing pad on the fixing
flage side for fixing the cutting discs since the fixing flange
cannot fix the discs alone on the spindle due to the thread
length (see fold-out page).
NOTE: Replace diamond cutting discs only in pairs.
Handling the wall grinder
CAUTION!
This appliance is designed for dry cutting only!
• Use a service line detector to check the internal and external
walls for concealed power, gas and water supply lines before
using the wall chaser.
• Select the desired groove width.
1.) Position the appliance with the roller (11) against the brick
wall.
2.) Now switch the appliance on and plunge it into the masonry
until the stop (7) makes contact.
3.) Then mill the groove in the masonry; pay attention to the
milling direction. The appliance must always run in reverse
rotation. Otherwise the appliance could be pushed out of the
cut in an uncontrolled manner.
• At ihe end of the groove, swivel the appliance out of the
groove and only then switch the appliance off.
• Now break out the resulting bar between the two grooves
using the hand chisel (16).
CAUTION!
Materials containing asbestos must not be machined!