Ryobi RTS10, Руководство оператора

Страница: 16 / 116

16 - English
TO ASSEMBLE THE LEG STAND
See Figure 7.
Assembly is best done in the area where the saw will be used.
If you are unsure about the description of any part, refer to
the drawing. If any parts are missing, delay assembling until
you have obtained the missing part(s).

Take the following from a small hardware pack:
16 bolts (1/4 - 20 x 1/2 in.)
16 hex nuts (1/4 - 20)

Take 4 legs and 8 braces from loose parts.

Place an upper brace inside two of the legs, with the
legs wide end up. (Upper braces have two large holes in
each end.) Make sure the dimples on the leg align with
the small holes on the brace.

Align the large holes on the brace and the legs. Insert
the bolts. Add hex nuts and hand tighten. Repeat for the
other upper brace. These are the front and back sets.

For the side sets, install an upper side brace on two legs.
Add hardware and finger tighten.
 Use the same steps to install the lower braces. Tighten
all hex nuts securely with the socket wrench.

Install a foot to the bottom of each leg.
 Move the leg set to desired location.
MOUNTING THE TABLE SAW BASE ON THE
LEG STAND
See Figure 8.

Take the following from a small hardware pack:
4 carriage bolts (1/4-20 x 1-3/8 in.)
4 hex nuts (1/4-20)
NOTE: This hardware was in the pack with hardware for
assembling the leg stand and leveling feet.

Place the table saw base on the leg stand. Align the holes
in the table with the holes in the end braces.

Place a bolt in each hole. Secure with a hex nut. Hand
tighten.

Repeat for three remaining holes. Tighten all hardware
securely with the socket wrench.
Fig. 8
Fig. 7
CARRIAGE
BOLT
UPPER
BRACE
UPPER SIDE
BRACE
HEX
NUT
LEG
CARRIAGE
BOLT
FOOT
HEX
NUT
LOWER SIDE
BRACE
LOWER
BRACE
CARRIAGE
BOLT
HEX
NUT
ASSEMBLY