Ryobi RPW190BL-G, Руководство по эксплуатации

Страница: 12 / 32

10
TROUBLESHOOTING
Problem Possible causes Solution
Pressure washer
does not start when
trigger is depressed
Power cord not connected to
power source.
Connect the power cord to a live 240V AC, 50 Hz AC
receptacle.
The on/off switch is in the OFF
position.
Press the on/off switch to turn on the product.
House/shop circuit breaker is
tripped.
Reset house/shop breaker. Make sure pressure washer is
connected to an individual branch circuit only. If using an
extension cord, make sure it is heavy enough to carry the
current of the pressure washer.
Water pressure in hose. Squeeze trigger to relieve water pressure.
Receptacle is bad. Try another receptacle.
Pump does not
produce pressure
Inadequate water supply. Provide adequate water flow.
Spray wand leaks. Check connections and /or replace wand.
Nozzle is clogged. Clean nozzle.
Pump is faulty. Contact authorized service center.
Air in line. Squeeze trigger on sprawy wand to remove air from line.
Water inlet filter is clogged or
dirty
Remove the water inlet fileter, rinse with warm water, then
replace in unit.
Machine does not
reach high pressure
Diameter of garden hose is too
small.
Replace with 19 mm garden hose.
Water supply is restricted. Check garden hose for kinks, leaks, and blockages.
Not enough inlet water. Open water source full force.
Hose is leaking. Replace hose.
Kink in hose. Eliminate kinks in hose.
No detergent Soap tank is empty. Add additional detergent to tank.
Water supply is inadequate or
clogged.
Check garden hose for kinks, leaks and blockages.
Wrong nozzle is attached. Attach blue or black soap nozzle.
Wand leaks O-ring needs replacing. Replace o-ring. If this does not correct the problem, contact
your authorized service center to purchase a new wand.