12
OPERATION
x10
1
2
4x
VI
1
2
3
1
2
6x
VI
1
2
3
4
3
1
2
4
STARTING A COLD ENGINE
1. Lay the product on the ground. Ensure
that the cutting means will not contact
anything when it starts to rotate. Press
the primer bulb 10 times.
NOTE:
After the 7th press, the fuel
should be visible in the primer bulb. If
not, continue pressing until the fuel is
visible.
Set the choke lever to
choke position.
2. Hold down the throttle lock and then
squeeze the throttle trigger completely
and pull the starter grip until the engine
attempts to start. Do not pull the starter
grip more than 4 times. Keep the throttle
trigger squeezed completely through
step 4.
3. Set the choke lever to
choke
position. Pull the starter grip until the
engine starts. Do not pull the starter grip
more than 6 times.
NOTE:
If the engine does not start,
repeat the procedure again from setting
the choke lever to
choke position.
4. Allow the engine to run for 10 seconds,
then set the choke lever to
position.
44
66
