3
ENGLISH (Original Instructions)
n
Keep the working area free from wires, stones and
debris.
n
Do not cut against hard objects. This could cause
injury or damage to the trimmer.
n
Do not use the trimmer to cut grass which is not in
contact with the ground. For example, do not cut
grass which is on walls or rocks.
n
Always use your trimmer in an upright position.
n
Keep hands away from the cutting line. Do not
attempt to remove cut material or to hold material to
be cut when the line is moving. Unplug the product
before clearing jammed material from the line. Do not
grasp the line when picking up or holding the product.
n
Be cautious even after the product is turned off. The
line coasts after turning off the power.
n
Do not use the trimmer in an enclosed or poorly
ventilated spaces or in the presence of inflammable
and/or explosive substances.
ELECTRICAL SAFETY
n
Make sure the power cord is properly located so that
it will not be stepped on, tripped over or otherwise
subjected to damage or stress.
n
Do not abuse the power cord. Never carry the
product by the cord. Never pull the plug out of the
power point by the cord. Keep the cord away from
heat, oil and sharp edges.
n
For outdoors work, use only suitably approved
extension cables with a minimum conductor cross
section of 1.5 mm
2
. The plug connectors must have
earthing contacts and be rainwater-proof.
n
Inspect extension cords for deterioration, cut or crack
in the insulation. Repair or replace the cords if any
defect is found.
n
A nameplate on the product indicates its voltage.
Never connect the product to an AC voltage that
differs from this voltage.
n
If the power cord or extension cable becomes
damaged during use, disconnect the cord from the
supply immediately. DO NOT TOUCH THE CORD
BEFORE DISCONNECTING THE SUPPLY.
n
Electrical power should be supplied via a Residual
Current Device (RCD) with a tripping current of not
more than 30 mA.
MAINTENANCE
WARNING
Before carrying out any maintenance operations,
cut off the electric power supply by disconnecting
the plug from the mains.
n
Follow instructions for changing accessories.
n
Keep the product dry, clean and free from oil and
grease.
n
Unplug the product before making adjustments or
repairs.
n
Check the product regularly to make sure that it will
operate properly and perform the intended function.
Check for alignment of moving parts, binding
of moving parts, breakage of parts and any other
condition that may affect the unit operation. Inspect
the unit's power connection. Any part that is damaged
should be properly repaired or replaced by a Ryobi
authorised service centre.
n
Keep the product clean of grass clippings and other
materials that may become lodged in the cutting lines
and air vents.
n
Never douse or squirt the product with water or any
other liquid.
n
After each use, clean with a soft, dry cloth. Do not
use detergents or solvents.
n
Use only manufacturers recommended replacement
parts and accessories.
n
If the cut-off blade is worn or broken, have it replaced
by an authorised service centre.
SPECIFICATIONS
Rated power:
300w
Rated voltage:
230V~240V
No load speed:
12,000/min
Cutting capacity:
25cm
Cutting line diameter:
1.2mm
Guaranteed sound power level: 94 dB(A)
Weight (without cable):
1.7 kg
Vibration: 1.7m/s
2
, K=1.5m/s
2
Sound Pressure Level:
LPA:78.5dB(A);
KPA:1.0 dB(A)