Ryobi RLT26C, Руководство оператора, Страница: 6 / 16

5
English (Original Instructions)
- Racing 106.3 dB (A)
- Equivalent A-weight sound power
level
106.3 dB (A)
Uncertainty K 2.5 dB
DESCRIPTION
3OHDVHUHIHUWRWKH¿JXUHVKHHW
1. Primer Bulb
2. Choke Lever
3. Fuel Cap
4. Starter Grip
5. Throttle Lock
6. On / Off Switch
7. Throttle
Trigger
8. Rear Handle
9. Front handle
10. Shaft
11. Deflector
12. String Head
13. Cutting Line
14. Idle Speed Screw
15. Spool retainer
16. Bolt
17. Wing nuts
18. Flat washer
19. Wrench (not provided)
20. Paper tube
21. Hex nut
ASSEMBLY
Please refer to Fig. 2.
UNPACKING
This product requires assembly.
1. Carefully remove the tool and any accessories from
the box. Make sure that all items listed in the packing
list are included.
2. Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
3. Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
tool.
4. If any parts are damaged or missing, do not operate
this tool until the parts are replaced. Failure to heed
this warning could result in serious personal injury.
PACKING LIST
Ŷ
Trimmer
Ŷ
Front handle assembly
Ŷ
Safety guard assembly
Ŷ
Cutting head assembly
Ŷ
Operator’s manual
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this
SURGXFW $Q\ VXFK DOWHUDWLRQ RU PRGL¿FDWLRQ LV
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
WARNING
Never attach or adjust any attachment while
power head is running. Failure to stop the engine
may cause serious personal injury.
WARNING
Be certain the knob is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious injury.
ATTACHING THE FRONT HANDLE (FIG. 2A)
1. Remove the bolt, flat washer, and wing nut from the
front handle.
2. Mount the front handle in front of the foam part.
3. Replace the bolt, flat washer, and wing nut. Tighten
the wing nut.
ATTACHING THE DEFLECTOR (FIG. 2B)
1. Loosen the hex nut.
2. Insert the shaft into the deflector.
3. Tighten the hex nut.
INSTALLING THE STRING HEAD (FIG. 2C)
1. Remove the paper tube.
2. Place the middle of the line under the hook/notch
inside the spool.
3. Feed the ends of the line through the eyelets on the
side of the Pro-cut I fixed line head.
4. Pull the line outwards so it is tight and even on both
sides of the spool.
5. Install Pro-cut™ head assembly on drive shaft.
Secure with spool retainer.