Ryobi RLT26C, Руководство оператора, Страница: 10 / 16

9
English (Original Instructions)
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM POSSIBLE CAUSE SOLUTION
Engine will not start. Power switch is off. Make sure Switch is in the ON or "I" position
No spark.
The spark plug may be damaged, remove it and check
for dirt and cracks. Replace with a new spark plug.
No fuel.
Push primer bulb until bulb is full of fuel. If bulb does
QRW¿OOSULPDU\IXHOGHOLYHU\V\VWHPLVEORFNHG&RQWDFW
D VHUYLFLQJ GHDOHU ,I SULPHU EXOE ¿OOV HQJLQH PD\ EH
ÀRRGHGSURFHHGWRQH[WLWHP
(QJLQHLVÀRRGHG
Remove spark plug, turn unit so spark plug hole is
aimed at the ground. Set start lever to “
” position
and pull starter cord 10 to 15 times. This will clear
excess fuel from engine. Remove any fuel which
splashed on the product. Clean and reinstall spark
plug. Clean up any spilled fuel and move at least 9m
away before restarting. Pull starter three times with
with start lever at “
”. If engine does not start, set
start lever to “ ” position and repeat normal starting
procedure. If engine still fails to start, repeat procedure
with a new spark plug.
Starter rope is harder to pull
now than when it was new.
Contact a servicing dealer.
Engine starts but will
not idle long enough to
engage throttle
Temperature can effect engine
idle time and rpm.
Flip start lever to RUN “ ” position and pull starter
until engine starts.
Engine does not stop
when switch is turned
off
Electrical connection is loose/
unplugged
Set the start lever to CHOKE “ ” to stop the engine.
Immediately stop using the product. Check electrical
connection on the bottom of the trimmer and make
sure it is properly connected. Contact servicing dealer
if the problem persists.
Engine starts but will
not accelerate. Engine requires approximately
three minutes to warm up.
Allow engine to completely warm up. If engine does
not accelerate after three minutes, contact a servicing
dealer.
Engine starts but will
only run at high speed
at half choke.
Carburetor requires
adjustment.
Contact a servicing dealer.
Engine does not reach
full speed and emits
excessive smoke.
1. Check oil fuel mixture.
2. Air filter is dirty.
3. Spark arrestor screen is
dirty.
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean air filter. Refer to
Cleaning the Air Filter
earlier in this manual.
3. Contact a servicing dealer.
Engine starts, runs,
and accelerates but will
not idle. Idle speed screw on
carburetor requires
adjustment
Contact servicing dealer if the problem persists.