Ryobi RC-3150B, Руководство по эксплуатации для владельца

Страница: 15 / 20

15
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE REMEDY
The compressor has
stopped and does not
start.
The compressor does not
reach the set pressure and
overheats easily.
Compressor does not
start.
Air leaking from the non-
return valve when the
compressor is not running.
Air pressure from the
regulator will not adjust.
The compressor is very
noisy and makes a
metallic knocking sound.
Bad electrical connections.
Overload cutout switch has
tripped.
Motor windings burnt out.
Compressor head gasket blown or
valve broken.
The reservoir has already fully
pressurised.
Faulty non-return valve.
The diaphragm within the
regulator body is broken.
Compressor damaged and needs
overhaul.
Check electrical connections. Clean
and tighten if necessary.
Switch off and wait approx 5 minutes.
Press the reset button and switch on
again.
Contact your nearest service agent.
Return the machine to your nearest
service agent.
Open drain valve to expel air.
Compressor should start again when
pressure reduces.
Drain receiver completely of air.
Remove the valve end plug,
Carefully clean the valve seat and the
gasket.
Reassemble.
Replace regulator.
Return the machine to your nearest
service agent.
SYMBOLS
SYMBOL SIGNAL MEANING
DANGER:
Indicates an imminently hazardous situation, which, if not avoided, will
result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not avoided, could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not avoided, may result
in minor or moderate injury.
CAUTION
(Without Safety Alert Symbol) Indicates a situation that may result in
property damage.