Ryobi R18CHS20, Руководство пользователя

Страница: 11 / 20

11
Getting started
2
1
2
1
2
7
3
4
1
2
5
Loosen the sprocket cover screw.
Adjust the chain tension until the gap
between the drive teeth and bar is
between 2.5 and 3.5 mm. To increase
the chain tension, turn the chain
tensioning screw clockwise. To reduce
the chain tension, turn the chain
tensioning screw counterclockwise.
NOTE: Frequently check the chain
tension while turning the chain
tensioning screw.
Tighten the sprocket cover screw.
NOTE: The temperature of the chain
increases during normal operation,
causing the chain to stretch. Check the
chain tension frequently and adjust as
required. A chain that is tensioned while
warm may be too tight upon cooling.
Make sure that the chain tension is
correctly adjusted as specified in these
instructions.
WARNING: Always hold the product
with the right hand on the rear handle
and the left hand on the front handle.
Start the product. Pull the trigger
release. Press the switch trigger.
2.5-3.5 mm