Ryobi PBT01B, Руководство оператора

Страница: 15 / 96

15 − English
Fig. 12
HEX SCREW
SIDE
HANDLE
BASE
45
30
15
0
Fig. 11
BASE
WORK
CLAMP
WORK
CLAMP KNOB
Fig. 13
SIDE
HANDLE
BASE
HEX SCREW
ASSEMBLY
WORK CLAMP
See Figure 11.
WARNING:
In some operations, the work clamp assembly may in-
terfere with the operation of the blade guard assembly.
Always make sure there is no interference with the blade
guard prior to beginning any cutting operation to reduce
the risk of serious personal injury.
The work clamp provides greater control by clamping the
workpiece to the fence or the saw table. It also prevents
the workpiece from creeping toward the saw blade. This is
very helpful when cutting compound miters. Depending on
the cutting operation and the size of the workpiece, it may
be necessary to use a C-clamp or other suitable clamp
instead of the work clamp to secure the workpiece prior to
making the cut.
To install the work clamp:

Place the work clamp shaft in one of the holes located
behind the miter fence.

Rotate the work clamp knob to move it up or down as
needed to secure the workpiece.
SIDE HANDLES
See Figures 12 - 13.
Side handles have been provided for both the left and the
right side of the saw.
To install side handles:

Align the holes in one of the side handles with the holes
in the saw base.

Insert the provided hex screws into the holes and tighten
securely using the blade wrench provided.

Repeat for other side handle.