Ryobi P600, Руководство оператора

Страница: 14 / 62

14
R2
R2
R3
1
2
1/4
1/2
3/4
1
R2
R2
R3
1
2
1/4
1/2
3/4
1
OPERATION
OPTIONAL WOODWORKING SUB-BASE
Turn the P600 laminate trimmer into a trim router with the op-
tional woodworking sub-base, Ryobi Part No. 200334001.
The woodworking sub-base accessory with handles is con-
venient when routing 4 in., 5 in., or 6 in. circular grooves. It
can also be used when routing grooves parallel to the edge
of the workpiece or with ball-bearing piloted bits.
The handles allow you to grasp and hold the trimmer with
two hands, similar to grasping and holding a router.
This trimmer is designed for roundover and other edging
operations up to 3/8 in. It is also useful for rabbeting or dado
operations with straight bits up to a maximum diameter of
1/4 in.
WARNING:
Do not use straight bits larger than 1/4 in. or edging bits
which cut a pattern larger than 3/8 in. with this trimmer.
Use of larger bits can result in loss of control and serious
personal injury.
WARNING:
Always use the laminate sub-base for laminate trimming.
Always use the woodworking sub-base for trim routing
operations. Use of the trimmer without a sub-base or us-
ing the incorrect sub-base can result in serious personal
injury.
WARNING:
Never install a bit larger than the opening of the trimmer
base. The use of larger bits can result in loss of control
and possible serious personal injury.
ATTACHING THE WOODWORKING SUB-BASE
ACCESSORY AND HANDLES
See Figure 10.

Turn the switch to OFF and remove the battery pack from
the trimmer.
 Turn the trimmer upside down to remove the four sub-
base screws and laminate sub-base.

Attach the woodworking sub-base accessory using the
same four screws.

Tighten the screws securely. Do not overtighten.

Turn the trimmer upright and thread the handles provided
into the threaded holes in the woodworking sub-base
accessory.

Tighten the handles securely. Check often to assure the
handles remain securely tightened.
Fig. 11
WORKPIECE
FINISHING
NAIL
ROUT CIRCULAR GROOVE CLOCKWISE
Fig. 10
SUB-BASE
SCREW(S)
WOODWORKING
SUB-BASE
ACCESSORY
HANDLE(S)
TRIMMER