7
Place the battery pack in the charger aligning raised rib
on the battery pack with the groove in the charger.
Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
NOTE: After charging is complete, the green LED will
remain on until the battery pack is removed from the
charger or charger is disconnected from the power
supply.
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
Do not place the charger and battery pack in an area of
extreme heat or cold. They will work best at normal room
temperature.
NOTE: The charger and battery pack should be placed
in a location where the temperature is more than 50°F
but less than 100°F.
OPERATION
When batteries become fully charged, unplug the charger
from the power supply and remove the battery pack.
To remove the battery pack from the charger, depress
the latches on each side of the battery pack.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack
cool down for approximately 30 minutes before attempting
to recharge.
NOTE: This situation only occurs when continuous use of a
tool causes the batteries to become hot. It does not occur
under normal circumstances. Refer to
“CHARGING A COOL
BATTERY PACK” for normal recharging of batteries. If the
charger does not charge your battery pack under normal
circumstances, return both the battery pack and charger
to your nearest Authorized Service Center for electrical
check.
P104 bAttERy PACK SHoWN AttACHEd to P113 CHARGER
Fig. 3
tEStING
INdICAtoR
CHARGING
INdICAtoR
CHARGEd
INdICAtoR
dEFECtIVE
INdICAtoR
PoWER oN
INdICAtoR
GREEN
LEd
REd
LEd
dEPRESS LAtCHES
to REMoVE
bAttERy PACK