Attaching and removing blower/vac tube (Fig. 1)
1.
Fit the guiding grooves in the front tube and rear tube
one on top of the other.
2.
Push two tubes firmly together until the clip in the
moulding engages.
3.
Slide the blower/vac tube into motor housing.
4.
Put the latches towards and turn the rubber parts around
90
o
close to the plastic hook on the rear tube. Make
sure the tube is connected firmly with the motor housing.
5.
Put the patio head into the front tube.
6.
Turn up the machine and repeat the above.
Mounting dust bag (Fig. 2)
1.
Put bracket of dust bag onto the lip of the motor housing
untill a click is heard as shown in Fig 2.
2.
Attach the dust bag hook to the blowing/vac tube.
ASSEMBLING
Before starting
Before starting the machine, make sure that the dust bag is
fitted and fastened correctly and that the shoulder strap is
adjusted to a suitable working position.
On/Off switch (Fig. 3)
Activate the switch by pressing the button on the side marked
with “I” (ON).
Activate the switch by pressing the button on the side marked
with “O” (OFF). When the machine is not used, switch it of f
and disconnect the electricity supply.
Blowing
Blow mode can be also used to clean corners, fences, walls,
wooded areas or beneath cars. Be careful how you point the
jet of air as it could move heavy material and cause injury or
damage.
1. Turn the blower/vac lever clockwise. (Fig. 4)
OPERATION
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Front Tube
Rear Tube
Latch
Motor Housing
Lip of the motor housing
Patio Head