Ryobi EJS700RG, Руководство по эксплуатации для владельца

Страница: 8 / 13

English
3
SPECIFICATIONS
Voltage 240 V 50 Hz
Input power 680 W
Stroke per minute 800 - 3000 min -1
Stroke length 21 mm
Max cutting capacity
Wood 85 mm
Steel 8 mm
FEATURES
KNOW YOUR SAW
Before attempting to use your saw, familiarize yourself
with all operating features and safety requirements.
ELECTRICAL CONNECTION
Your saw has a precision built electric motor. It should be
connected only to a power supply of the type specifi ed by
its rating plate. Do not operate this tool on direct current
(DC). A substantial voltage drop will cause a loss of power
and overheating. If your tool does not operate when
plugged into an outlet, double-check the power supply.
WARNING
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
suffi cient to infl ict severe injury.
OPERATION
SWITCH
See Figure 1.

To turn your saw ON, depress the switch.

Release trigger switch to turn your saw OFF.
LOCK-ON BUTTON
See Figure 1.
Your saw is equipped with a lock-on feature, which is
convenient when continuous cutting for extended periods
of time is required. To lock-on, depress the trigger switch,
push in and hold the lock-on button located on the side of
the handle, then release trigger switch. Release lock-on
button and your saw will continue running.
To release the lock, depress the trigger switch and release.
If you have the lock-on feature engaged during use and
your saw becomes disconnected from power supply,
disengage the lock-on feature immediately.
WARNING
Before connecting your saw to power supply source,
always check to be sure it is not in lock-on position
(depress and release trigger switch). Failure to do so
could result in accidental starting of your saw resulting
in possible serious injury. Also, do not lock the trigger on
jobs where your saw may need to be stopped suddenly.
TRANSPARENT GUARD
See Figure 3.
For your protection, a transparent guard has been included
with the saw. It is used to shield wood particles from the
eyes. The transparent guard is attached by placing it in
front of the blade area of the base and snapping it into the
tabs on the sides of the saw base. For removal, simply
pull the tap of the transparent guard. Make sure the saw is
unplugged before installation and removal.
NOTE: The transparent guard can only be used for
straight cutting.
TO INSTALL BLADES
See Figure 3 - 4.

Unplug the tool.
WARNING
Failure to unplug your saw could result in accidental
starting causing possible serious injury.

Turn the tool upside down.

Pull the tap of the transparent guard.

Rotate the quick release lever counter-clockwise and
hold in position.

Insert the saw blade into the groove in the roller guide,
making sure the back of the saw blade is properly
positioned in the groove.
NOTE: Only T-shank saw blades can be used.

Push the saw blade into the blade clamp as far as it
will go.

Release the quick release lever.

Install the transparent guard.