Ryobi EJS700RG, Руководство по эксплуатации для владельца

Страница: 11 / 13

English
6
WARNING
Failure to unplug your saw could result in accidental
starting causing possible serious injury.

Attach the dust port to the back of the base. You can
hear a click sound when it is locked securely.

Connect exhaust opening to dust collection system.
TO REMOVE:

Unplug your saw.

Directly pull the dust port out.
TO CONNECT DUST EXTRACTION SYSTEM (NOT IN-
CLUDED)

Unplug the tool.
WARNING
Failure to unplug your saw could result in accidental
starting causing possible serious injury.

Connect the nozzle of the dust collection system to
the dust port.
EDGE GUIDE
See Figure 11.
An edge guide is available for use with your saw. It can be
used for making crosscuts and rip cuts.
TO INSTALL:

Unplug your saw.
WARNING
Failure to unplug your saw could result in accidental
starting causing possible serious injury.

Insert arm of the edge guide through the two slots in
the base of your saw.

Adjust edge guide to the desired width and lock in
place with the edge guide screw.
WARNING
When servicing, use only identical replacement parts.
Use of any other part may create a hazard or cause
product damage.
LASER GUIDE
See Figure 12.
Depress the trigger switch to generate a red laser beam
on the work surface in front of the saw. Use the laser to
guide the saw along the line of cut.
LED WORKLIGHT
See Figure 12.
The jigsaw has a built-in LED worklight. This feature is
convenient when working in close or tight areas where
additional light is needed. Whenever the trigger switch is
depressed, the LED worklight will illuminate.
LIVE TOOL INDICATOR
This tool features a live tool indicator which illuminates as
soon as the tool is connected to the supply. This warns the
user that the tool is connected and will operate when the
switch is pressed.
MAINTENANCE
GENERAL
All other parts represent an important part of the class
II insulation system and should be serviced only by a
qualifi ed service technician.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents. Use clean cloths to remove dirt,
carbon dust, etc.
WARNING
Do not at any time let brake fl uids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
It has been found that electric tools are subject to
accelerated wear and possible premature failure when
they are used on fi berglass boats, sports cars, wallboard
or plaster.
The chips and grindings from these materials are highly
abrasive to electric tool parts such as bearings, brushes,
commutators, etc. Consequently, it is not recommended
that this tool be used for extended work on any fi berglass
material, wallboard or plaster. During any use on these
materials it is extremely important that the tool is cleaned
frequently by blowing with an air jet.
LUBRICATION
All of the bearings in this tool are lubricated with a
suffi cient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no
further lubrication is required.