Ryobi EDP2521L, Руководство по эксплуатации для владельца

Страница: 11 / 14

The laser beam should be aligned before being
used for the first time.
Turn on the laser.
Mark a cross as the target location to be drilled
on the workpiece.
Press the on/off to switch on the laser beam and
let the laser line on the workpiece.
Adjust the laser beam crosshairs to match with the
target drill position by slowly turning the laser head
to obtain a clear crosshair on the workpiece.
Switch on the drill press to drill the required hole
OPERATION
Change batteries:
Turn off the drill press and switch off the laser
beam.
Open the battery cover of the laser beam on/off
switch.
Replace the 2xAA batteries into the battery
compartment.
Switch on the laser beam and turn on the drill
press for drilling operation.
WARNING:
Use only correct batteries 2x AA size batteries.
Page 10
MAINTENANCE
Frequently blow out any dust that may accumulate inside the motor.
A coat of automobile type wax applied to the table and column will help to keep the surface clean.
If the power cord is damaged in any way, have it replaced immediately.
LUBRICATION
All of the ball bearings are packed will grease at the factory. They require no further lubrication.
Fig.10