9
OPERATION
REVERSIBLE
See Figure 4.
This tool has the feature of being reversible. The
direction of rotation is controlled by a lever located above
the switch trigger. With your screwdriver held in normal
operating position, the direction of rotation lever should
be positioned to the left of the switch for forward driving
operation. The direction of rotation is in reverse when
the lever is to the right of the switch.
The design of the switch will not permit changing the
direction of rotation while the screwdriver is running.
Release the switch trigger and allow the screwdriver to
stop before changing its direction.
Note:
Your screwdriver will not run unless forward/
reverse lever is pushed fully to the left or right.
INSTALLING/REPLACING
BIT HOLDER AND BITS
See Figure 5.
■
Unplug your screwdriver.
WARNING:
Failure to unplug your screwdriver could result in
accidental starting causing serious injury.
TO INSTALL OR REPLACE BITS:
■
Install 1/4 in. (6.4 mm) screwdriver bits by inserting
them into magnetic bit holder.
Note:
It is not necessary to remove adjustable
nosepiece to install or remove bits. The magnetic bit
holder shown in figure 5 illustrates the location of bit
holder inside nosepiece.
■
Replace 1/4 in. (6.4 mm) screwdriver bits by pulling
them out of magnetic bit holder.
FORWARD
REVERSE
Fig. 4
TO REMOVE MAGNETIC BIT HOLDER:
■
Pull adjusting sleeve. The adjusting sleeve and
adjustable nosepiece come off gear casing as a set.
■
Remove magnetic bit holder. Pull bit holder out with
pliers if you cannot remove it by hand.
TO REASSEMBLE BIT HOLDER AND NOSEPIECE:
■
Push bit holder into hex opening of spindle until ball
lock snaps in groove in bit holder shank.
■
Attach adjustable nosepiece to the gear case. Align
raised tab inside the adjustable nosepiece with the
groove on the gear case and push the nosepiece as
far as it will go.
Fig. 5
ADJUSTING
SLEEVE
GEAR CASING
1/4 in. (6.4 mm)
SCREWDRIVER
BIT
MAGNETIC BIT HOLDER WITH
1/4 in. (6.4 mm) HEX OPENING
ADJUSTABLE
NOSEPIECE
PULL TO REMOVE
ADJUSTABLE NOSEPIECE
ALIGN AND PUSH TO REPLACE
ADJUSTABLE NOSEPIECE
WARNING:
Your screwdriver should never be connected to a
power supply when you are assembling parts, making
adjustments, installing or removing bits, cleaning, or
when not in use. Disconnecting your screwdriver will
prevent accidental starting that could cause serious
personal injury.
