![background image](http://html.mh-extra.com/html/ryobi/ccw180/ccw180_operators-manual_1504170012.webp)
12
CAUTION:
Remove battery pack from unit. Fill oil tank with
Ryobi Bar and Chain Lubricant before starting the
chain saw. Failure to lubricate the chain will cause
damage to the bar and chain.
CHAIN OIL SYSTEM
See Figure 9.
Use Ryobi Bar and Chain Lubricant.
It is
formulated to perform over a wide temperature
range with no dilution required.
NOTE:
Do not use dirty, used or otherwise
contaminated oils. Damage may occur to the
bar or chain.
Carefully pour the bar and chain oil into the tank.
Check and fill the oil tank when battery is
recharged, or as needed.
Depress the oil tank cap several times to pump
the oil to the chain before starting the saw.
Depress the oil tank cap every 20-30 seconds
while cutting to keep the chain lubricated.
NOTE:
It is normal for lubricant to seep from the
saw when not in use. To prevent seepage, empty
the oil tank after each use. When storing the unit
for a long period of time (three months or longer) be
sure the chain is lightly lubricated; this will prevent
rust on the chain and bar sprocket.
APPLICATIONS
You may use this product for the following purposes:
Limbing and pruning branches from trees
Felling small trees (Cutting capacity: maximum
cut up to 228 mm; recommended cut: 177 mm)
Bucking the fallen tree into shorter lengths
This product will accept Ryobi One + 18 V lithiumion
battery packs and Ryobi One + 18 V nickel-cadmium
battery packs.
For complete charging instructions, refer to the
Operator’s Manual for your Ryobi One + battery
pack and charger models.
TO INSTALL / REMOVE BATTERY PACK
See Figure 8.
WARNING:
Always remove battery pack from your tool when
you are assembling parts, making adjustments,
cleaning, carrying, transporting or when not in use.
Removing battery pack will prevent accidental
starting that could cause serious personal injury.
NOTE:
To avoid serious personal injury, always
remove the battery pack and keep hands clear of
the lock-out button when carrying or transporting
the tool.
To install:
Place the battery pack in your chain saw. Align
raised rib on battery pack with groove in chain
saw’s battery port.
Make sure the latches on each side of the
battery pack snap in place and that battery
pack is secured in chain saw before beginning
operation.
To remove:
Locate latches on side of battery pack and depress
both sides to release the battery pack from the
chain saw.
CAUTION:
When placing battery pack in your chain saw, be
sure raised rib on battery pack aligns with groove
in chain saw’s battery port and latches snap in
place properly. Improper assembly of battery
pack can cause damage to internal components.
Fig. 9
Fig. 8
BATTERY
PACK
LATCHES
BATTERY
PORT
OPERATION