Ryobi Airwave RA-C2550-G, Руководство оператора

Страница: 15 / 19

9
tRoUBLesHootIng
PRoBLem cAUse PossIBLe soLUtIon
Compressor will not run Loss of power or overheating Check for proper use of extension cord
No electrical power Check to be sure unit is plugged in
Check fuse/breaker
Blown shop/house fuse Replace shop/house blown fuse
Shop/house breaker open Reset shop/house breaker, determining
why problem happened
Current limiting protector open Reset motor overload to restart after motor
has cooled.
Bad pressure switch Replace pressure switch
Tank is full of air Compressor will turn on when tank
pressure drops to cut-in pressure
Motor hums but cannot run or
runs slowly
Low voltage Check with voltmeter
Wrong gauge wire or length of
extension cord
Check for proper gauge wire and cord
length
Shorted or open motor winding Take compressor to service centre
Defective check valve or unloader Take compressor to service centre
Current limiting protector cuts
out repeatedly
Low voltage Check with voltmeter
Lack of proper ventilation/room
temperature too high
Move compressor to well-ventilated area
Wrong gauge wire or length of
extension cord
Check for proper gauge wire and cord
length
Air tank pressure drops when
compressor shuts off
Loose connections (fittings, tubing,
etc.)
Check all connections with soap and water
solution and tighten
Loose drain valve Tighten drain valve
Check valve leaking Take compressor to service centre
dAngeR
Do not disassemble check valve, tank drain
valve or pressure relief valve with air in
tank — bleed tank.
Excessive moisture in
discharge air
Excessive water in air tank Drain tank
High humidity Move to area of less humidity; use air line
filter