14
MOBILE AND WORKSHOP SERIES OPERATION MANUAL
October 2018 | Version: v1-0
Start Up
Machine Placement
Place the machine on a stable and flat surface.
Selecting Dies
Determine the crimping dimensions for the hose assembly and select the die set with the correct range that corresponds with the
required finished crimp diameter.
Example:
A crimping measurement of 17.0 mm requires the die set size 16 as it covers the
16-19 mm range.
Selecting the die set within the correct range will achieve the best crimping results.
Every die is marked with the smallest crimping measurement in the range.
Note!
Crimping outside the range is not recommended.
Using dies that are too small risks the ferrule becoming oval.
Operation
The crimping machine is switched on by turning the supply main power switch.
However, the motor won’t run until the crimping or retraction push button is pressed.
The motor stops automatically and the indicator light starts to flash. If the machine is idle for 6 seconds. The motor starts when the
crimping or retraction button is repressed.
MOBILE AND WORKSHOP CRIMPERS
OPERATION
Installing The Die Set
Quick Change (RY20CB and RY32CB)
Die set are stored in the storage locker and installed in the master dies with a quick change tool one complete set at a time.
Please note:
Changing the 10mm die set with the quick change tool is not recommended. The die set may get broken due to
the tool rod’s diameter. The 74mm die set and larger die sets have no quick change capabilities, these dies are too thin for quick
change tool holes.
1.
Before installing dies, make sure that master dies are clean.
2.
STOP THE MOTOR PRIOR TO CLEANING DIES.
3.
After the master dies are cleaned, start the motor and select manual mode.
4.
Set the swaging diameter dial to 0.0.
5.
Open the master dies.
6.
Insert the pins of the quick change tool into the mating hoes of the die set (Figure 4), turn the quick change tool clockwise and
pull the whole die set out.
7.
Hold the handle of the quick change tool as shown in Figure.4 and 5. making sure your hand does not get between the dies.
8.
Mount the die set between master dies so that the tool rod is fitted deep enough in the centering hole and start closing the dies
in manual mode. Die set installed Figure. 6.
Figure. 4
Figure. 5
Figure. 6